There are many reasons why one would need to toenail wood with the use of a framing nailer. This technique is done by driving a nail diagonally to connect with two boards which are met at a 90 degree angle. Such technique is being used widely in various construction sites. The most common reason for this is to get the boards that are not as straight or a little warped to stay in line correctly.

Tips on How to Toenail with Framing Nailer.

When it comes to framing walls, you certainly would want each of the studs to stay straight in order to get a maximum holding strength. So here is a guide on how to toenail with framing nailer.

Prepare your Framing Nailer

First of all, you have to load up your framing nailer gun with the most appropriate nails for the job. Usually, residential construction framing would make use of a 2.5 inch framing nails. Other construction jobs might also use other varieties of nails. It is important to use the right nailer for specific types of nails. After you have prepared the nailer, place its tip on the insertion spot, an area where you want the nails to be shot on the first board. The best area is about ¾ up to an inch coming from the corner where the two boards will often meet.

Tilt the Nailer and Pull the Trigger

After you have located the best area to shoot the nails, it’s time to begin. Simply tilt the framing nailer to an angle of about 60 degrees in order for the nail to be shot within an angle. After that, slowly pull the trigger in order to drive the nail diagonally towards one board going into another nail.

Repeat the Steps Over Again

Do the same steps with the rest of the nails in order to toenail the boards coming from the opposite side. The force applied by the framing nailer might jar the board a bit out of position. However, placing nails on the opposite sides can help to fix this and will then allow you to secure the boards in proper alignment. If needed, you can choose to tap the board securely into place using a hammer before and after you drive the second nail.

Things to Remember

You may need to toenail more frequently when it comes to framing a wall, rouging in a window or door. Although toe nailing using a hammer will certainly work, it is much easier and faster to make use of the framing nailer. Simply refer to the user manual of the framing nailer you are using to find more tips on toe nailing. Some user manuals also come with troubleshooting advice that you will find very useful. Read framing nailer reviews here

If there is a need to, adjust your framing nailer as well as the compressor to a proper pressure. This is to avoid driving in some partially sunken nails with the use of a hammer. Doing this can also help to prevent the possibility of chipped or split lumber. So follow these easy tips on how to toenail with framing nailer.